Thermostats
- Thread starter Karenxx67
- Start date
- Status
I use a Herpstat2 but that may be tougher to find in the UK. I recommend using a dimming thermostat with two outlets so you can keep separate control of cool and warm ends (and use a ceramic heat emitter to control overnight temps as needed). Something like a Microclimate Evo or Prime2. I've heard good things about that Habistats too. Swell Reptiles carries them.
SpacialCoogs
Sub-Adult Member
https://www.amazon.com/Inkbird-Ther...sr=8-5&keywords=reptile+thermostat+controller
I've heard good things about Inkbird
I've heard good things about Inkbird
Yeah that's a good point. I like using one that handles both so I can run both a halogen flood for the basking area and a heat projector/CHE for the cool side & nighttime. That's why I like having a model that can handle two separate controls.
Great. I hope it's helpful!
Right on the basking surface. If you have two, put one on a surface of the cool side. I used zip ties and sticky zip tie anchors to run the probes down the back of the tank to the floor then ran the probes onto the basking surface. They stay put in my setup but you may need to zip tie them down depending on where you mount them.
Basking side
Cool side
Cool side
Great so i have the probe on the basking spot and i also have the temp probe in the same place which is giving me the reading.
Its odd as i set the thermostat at 39 but the temp was climbing up above 41 according to the temp reader. I turned the thermostat down to 33 an the temp prob is now reading 37.7
Its odd as i set the thermostat at 39 but the temp was climbing up above 41 according to the temp reader. I turned the thermostat down to 33 an the temp prob is now reading 37.7
It usually controls the temps within a programmable range. I set mine to stay between 99 and 103f in the basking area. It may also take quite a while for the probe to get an accurate reading (half hour or more).
That I'm not sure of. Which model did you wind up getting? I'll do some digging and find out how it's supposed to work. It may just have a built in tolerance of a few degrees either way or there may be a way to set it.
- Status
Similar threads
Latest resources
-
General Care Practical tips: A healthy brumating bearded dragonPractical tips to help keep your bearded dragon healthy during brumation
- Shinryu
- Updated:
-
-
Lighting Beginner Guide to Bearded Dragon LightingA basic lighting setup for any bearded dragon.
- Shinryu
- Updated:
-
Lighting Introduction to UV LightingMake a more educated purchase on your next UVB light.
- Shinryu
- Updated:
-
General Care Bearded Dragons - Care SheetAn all-in-one guide to caring for your bearded dragons.
- Shinryu
- Updated:
Latest profile posts
Go88 là một trong những nhà cái cá cược trực tuyến hàng đầu với danh tiếng vững chắc trong cộng đồng người chơi.
Website: https://https://appgo88.link/
Tag: #appgo88link #go88link #Game_Go88 #Game_bài_Go88 #Cổng_game_Go88 #Tài_xỉu_Go88 #Nạp_tiền_Go88 #Rút_tiền_Go88 #play_Go88
Website:
https://smartcity.bandung.go.id/member/bsc3090527795d
Website: https://https://appgo88.link/
Tag: #appgo88link #go88link #Game_Go88 #Game_bài_Go88 #Cổng_game_Go88 #Tài_xỉu_Go88 #Nạp_tiền_Go88 #Rút_tiền_Go88 #play_Go88
Website:
https://smartcity.bandung.go.id/member/bsc3090527795d
Mirage came out of brumation on April 26. He was doing great. On May 2 he started acting funny. We just redid his tank, and he keeps going into one of his hides. He just lays there. He shows no intrest in food. HELP!
