BeardieMan7
Member
I recently got a 3d printer and thought that it would be cool if I could 3d print toys or hides for Rocky (aka 'The Rock'), my juvenile bearded dragon. Does anyone know if it would be safe?
3d printing for beardies?
- Thread starter BeardieMan7
- Start date
- Status
Wickedpogana
Juvie Member
I've always thought it would be cool to 3d print a background if the material was hard enough but you could always Grout over anything that's printed and seal it then of course its safeBeardieMan7":150uw5w4 said:
- Status
Similar threads
Latest resources
-
General Care Practical tips: A healthy brumating bearded dragonPractical tips to help keep your bearded dragon healthy during brumation
- Shinryu
- Updated:
-
-
Lighting Beginner Guide to Bearded Dragon LightingA basic lighting setup for any bearded dragon.
- Shinryu
- Updated:
-
Lighting Introduction to UV LightingMake a more educated purchase on your next UVB light.
- Shinryu
- Updated:
-
General Care Bearded Dragons - Care SheetAn all-in-one guide to caring for your bearded dragons.
- Shinryu
- Updated:
Latest profile posts
I just set Swordtail's timer for his bath and paused it so I could actually fill his soaking bowl up and he crawled over my phone and canceled the timer 
Mirage came out of brumation on April 26. He was doing great. On May 2 he started acting funny. We just redid his tank, and he keeps going into one of his hides. He just lays there. He shows no intrest in food. HELP!
