mb1994":nlmhywnv said:
Hey guys.
I'm about to build a birch plywood terrarium.
I am not planning on painting it, and will be using tiles for the substrate.
Do I need to seal the wood at all? I hear it takes up to a month to cure and would rather have it ready sooner than later.
Baltic/Russian Birch plywood is the only kind I'm aware of that is
all birch. It's of very high quality (more plies, heavier, very stable), and is preferred by cabinet makers. Depending on where you are, it can be gotten in 4' x 8' (122 cm x 244 cm) or 5' x 5' (152.5 cm x 152.5 cm) sheets (the latter is more common). As a rule, I don't like to cite vendors as sources, but in this case there's a lot of good information about it.
Ultimate Guide to Baltic Birch Plywood
I used (B/BB) ¾" (18mm) x 5' x 5' sheets, which got me a little bigger enclosure with fewer cuts (I don't have a table saw). I also designed the enclosure
around the 24" x 12" (nom.) tiles (cuz I don't have a tile saw/cutter either :roll: ). Finished size is 61.5"W x 25.75"D x 36"H (including a 9"H compartment for lighting, electrical, & storage). It sits on a 72"L folding table.
Whatever kind of birch plywood you decide on,
I would strongly urge you to seal it. :laughing6:
You
will thank yourself later. I used a
triple-thick water-based urethane (I used the same # of coats as regular urethane), but there are many other good
reptile-safe products. Curing time is dependent on a number of factors (temp, humidity, etc.); this stuff took about a week after the final coat, IIRC.
The best plywood in the world will still be affected by moisture/humidity. If it gets wet, it may raise, swell, and/or buckle the grain. If too dry (from warmer than room temp and low humidity) the veneer may still shrink or crack over time. Unsealed plywood will also absorb liquid & odors from
dragon droppin's, and the liquid from which can still trickle down between tiles--even with a moisture barrier under the tiles. ?
happens. :laughing6: I might not have believed it had it not happened to me personally, but somehow
ZARDOZ managed to poop right on the wall. I was
very glad I had sealed that plywood; it cleaned up
easily with
Nature's Miracle for Stinky Dragons, except for an unfinished strip I had used as a spacer between tile & wall. I had to replace that. (PEW!) :wink: