Moon4wolfgirl":3kb110aw said:
no he does not have a miter saw, we tried a saw but it kinda shatterd a little bit. blitz is an escape artist, i had a tote for him when he was little and i got the lid off and when i was gone he jumped out, luckily my grandma put him back in the cage. so im scared that he will jump out again
A soldering iron will make holes with out shattering plastic , if the plastic is already brittle , don't use the tub as it's lost it's structure strength , likely due to exposure to the sun.
Buy a new tote (they are very cheap).
Ventiliation for when dragon in tub with lid on (no holes in lid) I do 50 holes near the top of one end with a soldering iron, and 50 holes near the bottom of the opposite end (about 2" off the bottom) to provide air exchange.
To cut a hole in the lid , if you must , a fine electric soldering iron will do the job, just set up a rectangular or square or round guider of some kind, and let the iron melt a hole and then slowly follow the guide to make a hole of the chosen shape.
A Dremel with cutter / router bit will do the job too.
I wouldn't use a jigsaw or hacksaw on this kind of plastic.