Best way to put in a MVB

[qhgirl1]

I'm likely going to build my own enclosure 4x2x2 and would really like to use an MVB. What would be the best way to put one in an enclosure? Or would a separate UVB light and basking light be better in this type of enclosure? Thanks!

 

[1happymommy]

My 4x2x2 has a MVB mounted right inside the viv with a ceramic fixture. It's on the rightside and then I added a 24" regular florenscent fixture on the leftside for light. I love the MVB's I adjusted the highth of the basking spot to get the right temp.
Make sure you burn your MVB a day or so to get the right temp. I'm not sure why but when brand new they are really hot. I think it had a smell too.

We drilled holes in the top back wall and ran the cord along the ceiling out the hole. Then we added a ceramic heat emitter in the middle that is set on a temp control for nighttime temps. It only goes on if it gets colder than 70 for my viv. But most people say 60-65 is fine.

Here's a few pics for you.
http://s284.photobucket.com/albums/ll4/1happymommy/Harleys%20viv/

 

[absolutbill]

I almost have an enclosure finished for my dragon. I am in florida so night time heat is not a worry. I just loaded some pictures but I will try to describe? I have a 2'x4'x3' tall box. In the top of the box I wired one outdoor electrical box with the directional arms for flood lights, and on the opposite side I have a regular 4" electrical box with a ceramic outlet wired in.

The reason I went with 36" high after the box, fixture, and bulb I am still able to have a elevated basking spot while still staying the 12-14" away from the MVB. My fake rock work/basking spot will be 12-14 high I wanted to have a little elevation to climb?

Check out my tank it was up sidedown when the pictures were taken

http://www.facebook.com/album.php?aid=2011209&l=28cfd&id=1358951198