I can not seem to get my temps right at all on basking area
I have. 75 watt bulb and the t5 10 and my temp on basking spot likes to stay at 95ish but then when I use my gun and check the temp of the surface it is like 110
It also seems to take forever to heat up
It gets down to like 60
In there at night so I have a heat no light as well that I’ve been using during day as well to keep temps up but want to get everything right
It sounds like you're pretty close. What are you using to measure temps that is reading 95? If your temp gun is getting surface readings of 110, I'd probably adjust the lights based on that reading. I'd shoot for around 100-105 surface temps right below the bulb with some areas around that in the 90s. That gives some options for them to choose from. They'll move around a bit and bask at different temps during the day. You can later make tweaks based on their reaction (if they bask a lot in the hottest spot, you can try raising the temps a few degrees - if they stay to the side, lower the temps a few degrees etc).