I'm setting up my 40 gal tank and wanted opinions. I purchased a 24" T5 reptisun and to mount it on the inside of the tank I was planning on mounting it to a 1x6 along with a ceramic light socket. Then make a custom frame to put screen in the left over space. Also any recommendations on bulb wattage, figured got with a 75w or 90w with a dimmer switch.
40 gallon breeder set up
- Thread starter jren83
- Start date
- Status
With a 40g breeder (I'm guessing the sides will be about 18'' high) I would mount a T5 light on top at 18'' above the floor and 12'' or so above the basking spot. Provide at least a few hides/shade areas and this should give you a nice UVB gradient and output at the basking site. With basking light wattages, you may need to play around with it a bit. I use a 150w reptile basking light on an adjustable stand that gives me proper temps at 19'' up. You may find that a different wattage will work well in your enclosure. It's more a matter of trial and error. You want to get it so the wattage is high enough without having to engage the dimmer very much.
- Status
Latest resources
-
General Care Practical tips: A healthy brumating bearded dragonPractical tips to help keep your bearded dragon healthy during brumation
- Shinryu
- Updated:
-
-
Lighting Beginner Guide to Bearded Dragon LightingA basic lighting setup for any bearded dragon.
- Shinryu
- Updated:
-
Lighting Introduction to UV LightingMake a more educated purchase on your next UVB light.
- Shinryu
- Updated:
-
General Care Bearded Dragons - Care SheetAn all-in-one guide to caring for your bearded dragons.
- Shinryu
- Updated:
Latest profile posts
I just walked into my room and instead of looking at me, Swordtail's eyes darted directly to the ice cream drumstick I'm holding
